In this particular situation it seems there is some degree of corruption already, so the file system is re-mounted in read-only.Īlthough the entries in messages says recovery is completed, you can see from the /proc/mounts wether or not a partition is indeed read-write-enabled: cat /proc/mounts It supposedly does this in order to prevent data corruption, which is neat I am sure. Commit interval 5 secondsĮXT3-fs: mounted filesystem with ordered data mode.ĮXT3-fs error (device sda7): ext3_journal_start_sb: Detected aborted journalįrom what I have gathered, any linux installation will set its file system in a read-only mode if there is some indication of hard drive malfunction or some issues with regards to SAN-configuration. Some of the error messages you may get in your general Check Point logsĬPPRODIS_init_error_logging_ex: failed to set cyclic log file for product ‘cpshared’ application ‘PostgreSQLCmd’ file ‘/opt/CPshrd-R75.20/log/postgresqlcmd.elg’.Ĭvpnd_admin: Can opening TdError log file /opt/CPcvpn-R75.20/log/CvpndAdmin.log: Unknown error 4294967295Ĭvpnd_admin: ndb_open : failed for /opt/CPsuite-R75.20/fw1/database/fwauth.NDB: Unknown error 4294967295Ĭvpnd_admin: Users Database is lost: unable to reloadīp_init: FATAL: Module bpctl_mod not found.īp_init: chgrp: failed to get attributes of `/dev/bpctl0′: No such file or directoryīp_init: chmod: failed to get attributes of `/dev/bpctl0′: No such file or directoryĮXT3-fs: INFO: recovery required on readonly filesystem.ĮXT3-fs: write access will be enabled during recovery.
DISK MOUNT UTILITY FROM CHECK POINT SOFTWARE MANUAL
The /var-partition has entered a read-only state and had to be subjected to a manual file system check (fsck) in single user mode before allowing it to be set to read-write.Ī small disclaimer this post is written by a linux amateur, so there is probably some crucial theory left out and other, and perhaps better, ways to rectify similiar situations. =)Ĭonclusion (for those of you seeking the quick answer) Please note if your system has _not_ entered a read-only state and you are looking to resolve some of the issues below, you would be best off continuing your search. Underneath you’ll find some of the errors I got when experiencing this problem.
![disk mount utility from check point software disk mount utility from check point software](https://static.macupdate.com/img/blog/upload/20200624/05-disk-utility-will-look-like-this.jpg)
In general it behaves in such a way you’ll think “I bloody well hope I did backup the system recently”.
![disk mount utility from check point software disk mount utility from check point software](https://www.paragon-software.com/wp-content/uploads/2019/03/6.png)
You may experience issues like a Check Point installation not being responsive (processes not started, etc.) and your dmesg, messages, $FWDIR/log/fwd.elg and fwm.elg may be filled with all sorts of error messages indicating the lack of files or not being able to create files.